Results 131 to 140 of 2085
-
August 5th, 2009 12:36 PM #131
Guys
For those who wants to have an EB please email me sa jofel_riofrio*yahoo.com. I'll make a yahoogroups para mas mabilis tyo makakapagusap kung when and where yung EB. u can also txt me your email add sa 09228429321 para maadd ko din. hopefully we could set an EB before the end of august. Thanks
-
-
August 24th, 2009 12:53 AM #133
Dear Guys:
Just came from Gener's shop where I had my water separator cleaned (after about 3 years or so).
Well it wasn't as dirty as I suspected, but there was some dirt there anyways.
What was interesting that happened is that he brought out this factory manual for Mazda B2500's and Ford Rangers with WL-31 engines. He proposed for a little extra they would be willing to adjust my valves.
Sabi ko, what the heck nanduon na ako and hindi pa cla na-aadjust since nagsara yung Francisco Motors so they went ahead and did it.
Well it performed a lot better after the adjustment and a lot of the valve noise disappeared.
Lumakas ang hila especially sa pa-akyat. And all this despite the hot and humid weather we've been having.
You might want to consider having this done for your vehicles.
PLS PM me and I will give the the address and number of Gener's shop.
Regards,
Dusky Lim
-
-
Verified Tsikot Member
- Join Date
- Jul 2009
- Posts
- 18
September 17th, 2009 07:34 PM #135Hi!
Newbie po ko dito. Gusto ko po sana itanung kung anu cause ng panginginig kapag nag on ang AC? nagpalit na po ko ng engine supports and triny ko na din taasan yung menor. Bagong overhaul lang po yung R2 engine and na break in na siya slowly. Thanks po in advance sa advice>
-
Tsikoteer
- Join Date
- Jan 2008
- Posts
- 380
September 25th, 2009 09:17 AM #136
Pag-on ng aircon the vacuum switch will kick-in to increase the idle by increasing fuel delivery.
I assume na bagong gawa rin yung aircon system nyo. Ano po ba yung static pressure ng AC nyo pati na rin yung 'working pressures' baka kasi sobra yung freon charge.
Baka rin masyado mataas na yung adjustment ng idle. Ano po ba yung AC compressor nyo, sanden 508, 507.
How about your air filter, baka palyado na. For stock air filter eto po experience ko.
DAIWA- BAD, malaking bawas sa power at mausok.
Federal Mogul- ok
Vic- ok
Bosch-ok
-
Verified Tsikot Member
- Join Date
- Aug 2009
- Posts
- 137
September 27th, 2009 12:27 AM #137elo guys/gals..
ask lan po ako kun anu po masuggest nio na brand ng clutch disc para sa
b2200? balak ko po kasi palitan yun sa sasakyan namin. anu po din yun
dapat kasabay na dapat palitan nun.
tsaka pano ko po malalaman kun RF or WL yun engine..gas po yun samin..
Regards,
chinese
-
September 27th, 2009 01:50 PM #138
get the AISIN brand! replace the clutch pressure plate, clutch disc, release bearing and pilot bearing. replace the transmission oil too!
if your truck is gas fed, it won't be an RF or WL engine since these are diesels. yours maybe a 4G52 gas-fed, carburetor.. check your engine number.
-
-
September 28th, 2009 12:05 AM #140
Dear Sirs:
If I'm not mistaken, the RF engines are 2.2 liter uniflow diesel engines (meaning that the intake and exhaust are located on the same side of the engine).
While the WL series of engines are 2.5 liter crossflow engines (meaning the intake and exhaust are located across the engine).
The WL-31 is a naturally-aspirated engine (no turbo) while the WLT-31 has a turbocharger.
If your engine is gasoline then its not a diesel and can't be an RF or a WL engine.
Apologies to anyone who tried to contact me, for the last 3 days wala akong internet connection.
Regards,
Dusky Lim