Quote Originally Posted by Gumusut_Amige View Post
Weld preparation is poor. The WPS should have clearly specified what's to be done.

Given that this is a critical car component, a bevel should have been applied first to achieve a full penetration weld, or a fillet weld should have been completed around the entire joint.



so i looked under the two twist-beam cars i have here. wala talagang weld sa top and bottom. and there are actually holes there, probably so water doesn't pool and cause corrosion.

pero wala talagang weld penetration as can be seen. it's like the weld is just sitting on top of the metal like glue